Wilbur-curtis WB-14-60 Manuel d'utilisateur télécharger pdf

MODELS INCLUDED

• WB-14-12

• WB-14-60

CAUTION: Please use

this setup procedure

before attempting to use

this appliance. Failure to follow the

instructions can result in injury or the

voiding of the warranty.

WARNING HOT LIQUID,

Scalding may occur.

Avoid splashing.

WARNING: DO NOT

place this water boiler

closer than six [6] inches

from wall. Unit must have

adequate cross-ventilation.

CAUTION: DO NOT

connect this unit to hot

water. The inlet valve is

not rated for hot water.

FOR THE LATEST SPECIFICATIONS AND INFORMATION GO TO WWW.WILBURCURTIS.COM

Service Manual – WB-14 Water Boiler

Wilbur Curtis Company, inC.

Important Safeguards/Symbols

Symbols:

WARNINGS – To help avoid personal injury

Important Notes/Cautions – from the factory

Sanitation Requirements

This equipment is designed for commercial use. Any servicing

other than cleaning and routine maintenance should be per-

formed by an authorized Wilbur Curtis Company service techni-

cian.

• DO NOT immerse the unit in water or any other liquid

• To reduce the risk of re or electric shock, DO NOT open

service panels. No user serviceable parts inside.

• Keep hands and other items away from hot areas of the unit

during operation.

• Never clean with scouring powders or harsh chemicals.

INSTALLATION

This Curtis unit is pre-set and ready to go from the factory.

System Requirements:

• Water Supply : 20 – 90 PSI (Min Flow Rate 2 gpm) • Electrical: Refer to Electrical Schematic.

Factory Settings:

• Water Temperature: 200ºF • Water Volume: 14 Gallons

NOTE: A water ltration system must be used to help maintain trouble-free operation. In areas

with extremely hard water, we highly recommend the use of a Curtis approved water lter. (For

our full line of lters, please log on to www.wilburcurtis.com) A water ltration system will greatly

prolong the life of the unit and enhance the quality and taste of the product.

SETUP STEPS

1. The unit should be level (left to right - front to back), on a secure surface.

2. Install the supplied water faucet on the faucet shank in front of the unit.

NSF requires the following water connection:

1. A quick disconnect or additional coiled tubing (at least 2x the depth of the unit) is required

so that the unit can be moved for cleaning.

2. This unit must be installed with adequate backow protection to comply with applicable

federal, state and local codes.

3. Water pipe connections and xtures directly connected to a portable water supply shall be

sized, installed and maintained in accordance with federal, state, and local codes.

ISO 9001:2008 REGISTERED

WILBUR CURTIS CO.

6913 Acco Street,

Montebello, CA 90640-5403

For the latest information go to

www.wilburcurtis.com

Tel: 800/421-6150

Fax: 323/837-2410

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Wilbur Curtis Company, inC

MODELS INCLUDED • WB-14-12 • WB-14-60CAUTION: Please use this setup procedure before attempting to use this appliance. Failure to follow the instr

Page 2 - Setup Steps Continued

2 1 2 3 4 5 6 7 8 91011121314151617181919A202122DESCRIPTIONPART №ITEMWC-5602WC-6118-01WC-4303WC-5335WC-5502-01WC-5510WC-2401WC-3528WC-5334WC- 501WC-

Page 3 - Illustrated Parts List

Illustrated Parts List312345678910111919A13141512161718202122

Page 4 - TROUBLE SHOOTING

PROBLEM: WATER OVERFLOWING.POSSIBLE CAUSESOLUTIONTurn power off and observe water level. If water continues to ow into the heating tank, clean or rep

Page 5 - Adjustment

TROUBLE SHOOTING CONTINUED:Replace thermostat if contacts are open when knob is fully clockwise and water temperature is less than 190º F. You will me

Page 6 - Electrical Diagram – WB-14-12

Electrical Diagram – WB-14-126

Page 7 - Electrical Diagram – WB-14-60

Electrical Diagram – WB-14-607

Page 8 - Product Warranty Information

FOR THE LATEST SPECIFICATION INFORMATION GO TO WWW.WILBURCURTIS.COMPrinted in U.S.A. 8/2013 F-1981 Rev EWILBUR CURTIS CO., INC.6913 Acco St., M